#CISCO LAB ROUTER ON A STICK MANUAL#
Instructor Note: Refer to the Instructor Lab Manual for the procedures to initialize and reload devices. If you are unsure, contact your instructor. Note: Make sure that the routers and switches have been erased and have no startup configurations. Refer to the Router Interface Summary Table at the end of the lab for the correct interface identifiers. Depending on the model and Cisco IOS version, the commands available and output produced might vary from what is shown in the labs. Other routers, switches and Cisco IOS versions can be used. The switches used are Cisco Catalyst 2960s with Cisco IOS, Release 1 5.0(2) (lanbasek9 image). Note: The routers used with CCNA hands-on labs are Cisco 1 941 Integrated Services Routers (ISRs) with Cisco IOS, Release 1 5.2(4)M3 (universalk9 image). Test your knowledge by trying to configure the devices without referring to the appendix. However, the required configuration commands are provided in Appendix A of this lab. Note: This lab provides minimal assistance with the actual commands necessary to configure trunk-based inter-VLAN routing.
In this lab, you will configure trunk-based inter-VLAN routing and verify connectivity to hosts on different VLANs as well as with a loopback on the router.
In this method, the physical router interface is divided into multiple subinterfaces that provide logical pathways to all VLANs connected. This method is also known as router-on-astick inter-VLAN routing.
Part 3: Configure Trunk-Based Inter-VLAN RoutingĪ second method of providing routing and connectivity for multiple VLANs is through the use of an 802.1Q trunk between one or more switches and a single router interface. Part 2: Configure Switches with VLANs and Trunking Part 1: Build the Network and Configure Basic Device Settings Switch Port Assignment Specifications Ports CCNA RSE 6.3.3.7 Lab – Configuring 802.1Q Trunk-Based Inter-Vlan Routing Answers
0 kommentar(er)
